How to control Sanyo projector with Wings Platinum 4.25A

Morev · 2. Apr 2012, 20:54

Hello Forum,
is there any way to control Sanyo projector with Wings? The software and the beamer are in one local area connection. I tried with adding of Serial / LAN port, then in the properties with use driver i choose a driver who was modified by me and applied to Sanyo commands. But without any results. That what i want is to control the shutter of the projectors.
Thanks for your answer:)

Patrick Zorn · 3. Apr 2012, 07:27

Good Morning Morev,

have you activated the "Device Ports"? The shown symbol in the toolbar should appear in grey. Just with active Device Ports the signal is been processed and sent.

Device Ports active.png: (34.99 KiB) 830-mal heruntergeladen

Have you checked if the commands are going out?

Best regards
Patrick Zorn

Morev · 3. Apr 2012, 16:21

Yes:) When i enable the Device Port the Device goes in Active status, but i don't see any commands.

Patrick Zorn · 4. Apr 2012, 06:33

Good morning Morev,

can you please just send me the project file (*.pt4 - file) so i can check your application. I also would need the driver file you have written.
My email: P.Zorn@AVStumpfl.com

best regards
Patrick Zorn