SoundLight USB DMX One

[Weaver]

I am trying to use for the first time the Soundlight USB DMX One but am unable to get valid DMX data under Wings 4.25. With the demo version of Lightdesk Scanshow that comes with the unit I have no problems to comunicate with the unit and control DMX Out. I notice that when correct comunication is established with the host CPU the LED on the unit flashes quickly green/red and the DMX modules in the chain show that a correct DMX stream is being recieved. When in Wings I am able to add the port and then add the devices. In fact when I add the port if I change the "interface for output" to 2 I get the message "unable to open DMX output" so it would appear that Wings is speaking to the unit. When I activate the devices the unit is shown as "Active" but the LED changes very slowly red/green and the DMX units indicate a fault in DMX data. I am using my MD licence with show control in case of version limitations. As usual this is for an installation early next week and it is the last thing I have to get working :-) Thanks to anyone that can give me any tips on how to proceed

[Weaver]

OK, I will reply to myself !! Actually "reading" some other posts in German I found that the driver that comes on the Soundlight CD does not work but the one at pcdmx.com does. It is only available in the German language version of the web here http://www.pcdmx.de/ger/hardware/usb/us ... mx-one.htm